Innovv Camera add to the CANsmart/ezCAN
The red and black wires must go directly to the battery, only the yellow wire can be connected to the CANsmart. The camera needs to be connected to constant power (battery) so that it will properly shut down and save the last recorded clip.
The yellow is to be connected to the positive wire one of the circuits on the CANsmart, you must then open the CANsmart software and set the circuit to "simple circuit over-ride"
Mating connectors for a plug and play installation can be found here:
For use with Circuit 1 & 2 or newer gen2
CANsmart
- 3 Pin Crimp On - https://www.twistedthrottle.com/denali-3-pin-waterproof-connector-set-male-female-connectors-with-terminals-and-seals
For use with Circuit 3 & 4 for the older
CANsmart
