Troubleshooting Gen1 Denali DM, Denali DR,DX, and Denali D4 (single intensity)

Gen 1 Denali DM, Denali DR,DX, and Denali D4 Problems and Troubleshooting Q/A

(single intensity)

No illuminations from light pods or switch indicator lights Check for loose white trigger wire and ground wire on bike and for loose wires on the Denali harness. 1
Switch illuminates*, but one or both light pods have no function. Check fuse and loose wires on the Denali harness. 1 2 
One light pod has no function, the other operates normally.  Check for loose wires on the Denali harness. If nothing is found, first plug the left pod into the right harness and the right pod into the left harness. If a light pod is faulty, you will see no change. If the non-functioning light pod now works and the previously functioning light pod now doesn’t, a portion of the harness is faulty. Replace the faulty components. 1  2

*Switch is illuminated Green when lights are off, Amber when in on position.

1 If there is still no improvement, replace the switch.

2 If there is still no improvement, replace relay.

TT-D2.CONTROLLER.rev3

https://4695408.app.netsuite.com/app/common/item/item.nl?id=16559 DENALI Replacement Parts: dual-intensity controller (Rev:03, Potted, M/F ext.)

Replacement single intensity switch disco'd and OOS 06/29/2022 - TT-D1.SWITCH.002
Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

Still need help? Contact Us Contact Us